Preparing For A Wall Tile Installation


Before you begin a wall tile installation there may be a few tasks you might need to perform. These tasks will prepare your room and walls for tiling.

Before you begin a wall tile installation, there may be a few tasks you may need to perform. They will prepare your walls for the perfect surface for tiling.

They will also help to make your tiling job go smoother, and your tiling results look much more professional.

Tile adhesive will adhere to many different surfaces, but for a professional looking tiling job some wall coverings need to be removed before a new wall tile installation

If you will be installing new wall tile, it's best to remove the old wall tiles, wood paneling, loose paint or wallpaper first. .

In most cases once you eliminate the old wall finish the wall underneath needs a bit of work. It may be as simple as patching drywall or plaster.

But sometimes the wall underneath is so damaged until patching it up is just not enough.

You'll need to tear down the old drywall and install it new, And for wet areas like tub surrounds and shower walls, you'll need to install cement backerboard or fiberboard instead.

These tile underlayments are different than drywall. Drywall has a paper covering which is perfect for installing tile in dry areas but will promote mold and mildew in wet areas.

Cement backerboard and fiberboard are specially made to repel water and mold making for the perfect tile underlayment for wall sections that are prone to getting wet.

Just click on the picture below for the information you are interested in and you'll be taken to That Page.

Tips To Help Make Tiling The Bathroom Or kitchen A Much Smoother Job

When you plan ahead tiling the bathroom or kitchen will go much smoother. Planning will help you to achieve more attractive and professional looking results for your kitchen or bathroom tile installation. It also helps in organizing the actual job of tiling.

Removing bathroom fixtures Before Tiling A Bathroom

When tiling a bathroom, it's always best to remove bathroom fixtures out of your way. It will make installing bathroom wall tile and bathroom floor tiles much easier, And make your bathroom tile installation look much more professional.

Ceramic Tile Removal From Walls

If your existing Ceramic tiles were installed relatively recent, they might have been attached to the drywall with tile mastic. If this is the case, you may be able to perform the task of ceramic tile removal by just prying off the old Ceramic tiles with a putty knife.

Patching Drywall And Plaster

 if you've removed an old wall covering, chances are you will need to do the task of patching drywall to get the wall ready for tiling.

Patching drywall can be a very simple. Usually, it only takes a little spackling compound, mesh tape, and tile adhesive

Installing Drywall

Sometimes walls are just too damaged where patching it up is just not enough. You'll probably need just to tear down the old drywall and install it new.

Installing drywall is relatively easy, and it leaves you with a nice flat, smooth. Plumb surface for your new tile installation.

Installing Drywall

 Planning your Ceramic Tile Layout For A New wall Tile Installation

planning your ceramic tile layout first by dry laying your wall tiles makes the actual tile installation go a lot smoother, And it also makes for a more professional looking tiling job.

It's ideal for tiling bathroom walls, installing kitchen wall tiles or any other wall you may be tiling.

Leaving Wall Tile Installation< >Go To Homepage

›› Wall Tile Installation